Reference Guide

Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant FTOS Command Line Reference Guide .
The following is a list of the FTOS version history for this command.
Version 9.0.0.0 Introduced on the Z9000.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.3.10.0 Introduced on the S4810.
ipv6 access-list
Configure an access list based on IPv6 addresses or protocols.
S4820T
Syntax
ipv6 access-list access-list-name
To delete an access list, use the no ipv6 access-list access-list-name
command.
Parameters
access-list-name Enter the access list name as a string, up to 140 characters.
Defaults All access lists contain an implicit “deny any”; that is, if no match occurs, the packet is
dropped.
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant FTOS Command Line Reference Guide .
The following is a list of the FTOS version history for this command.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.3.7.0 Introduced on the S4810.
Version 8.4.2.1 Introduced on the S-Series.
Version 8.2.1.0 Introduced on the E-Series ExaScale.
Version 7.8.1.0 Introduced on the C-Series. Increased the name string to accept up
to 140 characters. Prior to version 7.8.1.0, names are up to 16
characters long.
Version 7.4.1.0 Introduced on the E-Series TeraScale.
Usage
Information
The number of entries allowed per ACL is hardware-dependent. For detailed specification on
entries allowed per ACL, refer to your line card documentation.
Related
Commands
show config — views the current configuration.
716