Reference Guide

27
IPv6 Basics
IPv6 basic commands are supported on the Dell Networking S4820T platform.
NOTE: For information about the Dell Networking operating software (FTOS) version and platform that supports
IPv6 in each software feature, refer to the IPv6 Addressing chapter of the FTOS Configuration Guide .
clear ipv6 fib
Clear (refresh) all forwarding information base (FIB) entries on a linecard or stack unit.
S4820T
Syntax
clear ipv6 fib linecard slot | stack-unit unit-number
Parameters
slot Enter the slot number to clear the FIB for a linecard.
unit-number Enter the stack member number.
The range is from 0 to 11 for the S4820T.
Command Modes EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant FTOS Command Line Reference Guide .
The following is a list of the FTOS version history for this command.
Version 9.0.0.0 Introduced on the Z9000.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.3.7.0 Introduced on the S4810.
Version 8.2.1.0 Introduced on the E-Series ExaScale.
Version 7.8.1.0 Introduced on the C-Series and S-Series.
Version 7.4.1.0 Introduced on the E-Series TeraScale.
721