Reference Guide

Destination Dist/Metric, Gateway, Last Change
----------------------------------------------
C 2001::/64 [0/0]
Direct, Gi 1/1, 00:28:49
C 2002::/120 [0/0]
Direct, Gi 1/1, 00:28:49
C 2003::/120 [0/0]
Direct, Gi 1/1, 00:28:49
C 2004::/32 [0/0]
Direct, Gi 1/1, 00:28:49
L fe80::/10 [0/0]
Direct, Nu 0, 00:29:09
Example
(Summary)
FTOS#show ipv6 route summary
Route Source Active Routes Non-active Routes
connected 5 0
static 0 0
Total 5 0
Total 5 active route(s) using 952 bytes
trust ipv6-diffserv
Allows the dynamic classification of IPv6 DSCP.
S4820T
Syntax
trust ipv6-diffserv
To remove the definition, use the no trust ipv6-diffserv command.
Defaults none
Command Modes CONFIGURATION-POLICY-MAP-IN
Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant FTOS Command Line Reference Guide .
The following is a list of the FTOS version history for this command.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.3.7.0 Introduced on the S4810.
Version 8.4.2.1 Introduced on the C-Series and S-Series.
Version 8.2.1.0 Introduced on the E-Series ExaScale.
Version 7.4.1.0 Introduced on the E-Series TeraScale.
Usage
Information
When you configure trust IPv6 diffserv, matched bytes/packets counters are not incremented
in the show qos statistics command.
Trust diffserv (IPv4) can co-exist with trust ipv6-diffserv in an Input Policy Map. Dynamic
classification happens based on the mapping as shown:
743