Reference Guide

iscsi aging time
Set the aging time for iSCSI sessions.
S4820T
Syntax
iscsi aging time time
To remove the iSCSI session aging time, use the no iscsi aging time command.
Parameters
time Enter the aging time for the iSCSI session. The range is from 5 to
43,200 minutes.
Defaults 10 minutes
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant FTOS Command Line Reference Guide .
The following is a list of the FTOS version history for this command.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.3.12.0 Introduced on the S4810.
Version 8.3.16.0 Introduced on MXL 10/40GbE Switch IO Module.
iscsi cos
Set the QoS policy that is applied to the iSCSI flows.
S4820T
Syntax
iscsi cos {enable | disable | dot1p vlan-priority-value
[remark] | dscp dscp-value [remark]}
To disable the QoS policy, use the no iscsi cos command.
Parameters
enable Enter the keyword enable to allow the application of preferential
QoS treatment to iSCSI traffic so that the iSCSI packets are
scheduled in the switch with a dot1p priority 4 regardless of the VLAN
priority tag in the packet. The default is: the iSCSI packets are
handled with dotp1 priority 4 without remark.
disable Enter the keyword disable to disable the application of preferential
QoS treatment to iSCSI frames.
dot1p vlan-
priority-value
Enter the dot1p value of the VLAN priority tag assigned to the
incoming packets in an iSCSI session. The range is from 0 to 7. The
default is the dot1p value in ingress iSCSI frames is not changed and
746