Reference Guide

is the same priority is used in iSCSI TLV advertisements if you did not
enter the iscsi priority-bits command.
dscp dscp-value Enter the DSCP value assigned to the incoming packets in an iSCSI
session. The valid range is from 0 to 63. The default is: the DSCP value
in ingress packets is not changed.
remark Marks the incoming iSCSI packets with the configured dot1p or DSCP
value when they egress to the switch. The default is: the dot1and
DSCP values in egress packets are not changed.
Defaults Disabled.
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant FTOS Command Line Reference Guide .
The following is a list of the FTOS version history for this command.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.3.12.0 Introduced on the S4810.
Version 8.3.16.0 Introduced on MXL 10/40GbE Switch IO Module.
Usage
Information
By default, iSCSI flows are assigned to dot1p priority 4.
iscsi enable
Globally enable iSCSI optimization.
S4820T
Syntax
iscsi enable
To disable iSCSI optimization, use the no iscsi enable command.
Parameters
enable Enter the keyword enable to enable the iSCSI optimization feature.
Defaults Disabled.
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant FTOS Command Line Reference Guide .
The following is a list of the FTOS version history for this command.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.3.12.0 Introduced on the S4810.
747