Reference Guide

iscsi target port
Configure the iSCSI target ports and optionally, the IP addresses on which iSCSI communication is monitored.
S4820T
Syntax
iscsi target port [tcp-port-2...tcp-port-16]ip-address [ip-
address]
To remove the configured iSCSI target ports or IP addresses, use the no iscsi target
port command.
Parameters
tcp-
port-2...tcpport-
16
Enter the tcp-port number of the iSCSI target ports. The tcp-port-
n is the TCP port number or a list of TCP port numbers on which the
iSCSI target listens to requests. Separate port numbers with a
comma. The default is
860, 3260.
ip-address
(Optional)
Enter the ip-address that the iSCSI monitors. The ip-address specifies
the IP address of the iSCSI target.
Defaults 860, 3260
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant FTOS Command Line Reference Guide .
The following is a list of the FTOS version history for this command.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.3.12.0 Introduced on the S4810.
Version 8.3.16.0 Introduced on MXL 10/40GbE Switch IO Module.
Usage
Information
You can configure up to 16 target TCP ports on the switch in one command or multiple
commands.
When you use the no iscsi target port command and the TCP port you wish to delete
is one bound to a specific IP address, the IP address value must be included in the command.
show iscsi
Display the currently configured iSCSI settings.
S4820T
Syntax
show iscsi
Command Modes
• EXEC
749