Reference Guide

128M bytes of boot flash memory.

1 52-port GE/TE/FG (SE)

52 Ten GigabitEthernet/IEEE 802.3 interface(s)

FTOS#

FTOS#config t

FTOS(conf)#int te 0/5

FTOS(conf-if-te-0/5)#no shut

FTOS(conf-if-te-0/5)#

FTOS(conf-if-te-0/5)#ipv6 nd prefix FEC0::/10

FTOS(conf-if-te-0/5)#

FTOS(conf-if-te-0/5)#show conf

interface TenGigabitEthernet 0/5

ip address 78.21.1.3/24

ipv6 nd prefix fec0::/10

flowcontrol rx on tx on

no shutdown

FTOS(conf-if-te-0/5)#

FTOS#

upgrade

Upgrade the bootflash image or system image of the management unit.

S4820T

Syntax

upgrade {boot | system} {ftp: | scp: | tftp: | flash: {A: |B:}

| stack-unit | usbflash | slot0:} file-url

Parameters

boot Enter the keyword boot to change the boot image.

system Enter the keyword system to change the system image.

ftp: After entering the keyword ftp:, you can either follow it with the

location of the source file in this form:

userid:password@hostip/filepath or press Enter to

launch a prompt sequence.

scp: After entering the keyword scp:, you can either follow it with the

location of the source file in this form:

userid:password@hostip/filepath or press Enter to

launch a prompt sequence.

slot0: After entering the keyword slot0:, you can either follow it with the

location of the source file in this form: //hostlocation/

filepath or press Enter to launch a prompt sequence.

tftp: After entering the keyword tftp:, you can either follow it with the

location of the source file in this form: //hostlocation/

filepath or press Enter to launch a prompt sequence.