Reference Guide

Version 8.3.19.0 Introduced on the S4820T.
Version 8.3.12.0 Introduced on the S4810.
Version 8.3.11.1 Introduced on the Z9000.
Usage
Information
Dell Networking recommends configuring metrics on all interfaces. Without configuring this
command, the IS-IS metrics are similar to hop-count metrics.
isis network point-to-point
Enable the software to treat a broadcast interface as a point-to-point interface.
S4820T
Syntax
isis network point-to-point
To disable the feature, use the no isis network point-to-point command.
Defaults Not enabled.
Command Modes INTERFACE
Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant FTOS Command Line Reference Guide .
The following is a list of the FTOS version history for this command.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.3.12.0 Introduced on the S4810.
Version 8.3.11.1 Introduced on the Z9000.
isis password
Configure an authentication password for an interface.
S4820T
Syntax
isis password [hmac-md5] password [level-1 | level-2]
To delete a password, use the no isis password [password] [level-1 |
level-2] command.
Parameters
encryption-type (OPTIONAL) Enter 7 to encrypt the password using DES.
hmac-md5 (OPTIONAL) Enter the keywords hmac-md5 to encrypt the password
using MD5.
784