Reference Guide

Control and Monitoring

This chapter contains the commands to configure and monitor the system, including Telnet, file transfer protocol (FTP),

and trivial file transfer protocol (TFTP) as they apply to the following Dell Networking S4820T platform.

NOTE: This command replaces the enable optic-info-update interval command to update

information on temperature and power monitoring in the simple network management protocol (SNMP)

management information base (MIB).

asf-mode

Enable alternate store and forward (ASF) mode and forward packets as soon as a threshold is reached.

S4820T

Syntax

asf-mode stack-unit {unit-id | all} queue size

To return to standard Store and Forward mode, use the no asf-mode stack unit

command.

Parameters

unit-id Enter the stack member unit identifier of the stack member to reset.

The S4820T range is from 0 to 11.

NOTE: The S4820T commands accept Unit ID numbers from 0 to

11, though S4820T supports stacking of up to six units with FTOS

version 8.3.12.0.

queue size Enter the queue size of the stack member. The range is from 0 to 15.

Defaults Not configured

Command Modes CONFIGURATION

Command History

This guide is platform-specific. For command information about other platforms, refer to the

relevant

FTOS Command Line Reference Guide

The following is a list of the FTOS version history for this command.

Version 8.3.19.0 Introduced on the S4820T.

Version 8.3.11.0 Introduced on the Z9000.

Version 8.3.7.0 Introduced on the S4810.