Reference Guide

Usage
Information
You must save the configuration and reload the system to implement ASF. When you enter the
command, the system sends a message stating that the new mode is enabled when the system
reloads.
cam-acl
Allocate content addressable memory (CAM) for IPv4 and IPv6 ACLs.
S4820T
Syntax
Parameters
default Use the default CAM profile settings and set the CAM as follows:
• L3 ACL (ipv4acl): 4
• L2 ACL(l2acl): 6
• IPv6 L3 ACL (ipv6acl): 0
• L3 QoS (ipv4qos): 2
• L2 QoS (l2qos): 1
• OpenFlow: 0 (disabled)
• FCoE (fcoeacl): 0 (disabled)
• iSCSI Optimization (iscsioptacl): 0 (disabled)
Allocate space to each CAM region.
Enter the CAM profile name then the amount of CAM space to be
allotted. The total space allocated must equal 13. The ipv6acl range
must be a factor of 2.
Enter 4 or 8 for the number of OpenFlow FP blocks.
• 4: Creates 242 entries for use by the OpenFlow controller (256
total entries minus the 14 entries reserved for internal
functionality)
• 8: Creates 498 entries for use by the OpenFlow controller (512
total entries minus the 14 entries reserved for internal
functionality)
Using the fcoe parameter, enter the number of FP groups to be
allocated for FCoE transit. Enter
1 – 6; maximum six groups. Each
group has 128 entries, creating a total of 768 possible entries for FCoE
FP groups. The value given must be an even number.
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant FTOS Command Line Reference Guide .
The following is a list of the FTOS version history for this command.
80