Reference Guide

Version 9.2(0.2) Added support for the fcoe parameter on the S4810 and S4820T.
Version 9.1.(0.0) Added support for OpenFlow on the Z9000.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.3.12.0 Added the keywords fcoeacl and iscsioptacl on the S4810.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.1.0 Added the keywords ecfmacl, vman-qos, and vman-dual-
qos.
Version 8.2.1.0 Introduced on the S-Series.
Version 7.8.1.0 Introduced on the C-Series.
Usage
Information
For the new settings to take effect, save the new CAM settings to the startup-config (write-
mem or copy run start) then reload the system.
The total amount of space allowed is 16 FP Blocks. System flow requires three blocks and
these blocks cannot be reallocated. The ipv4acl profile range is from 1 to 4.
When configuring space for IPv6 ACLs, the total number of Blocks must equal 13.
Ranges for the CAM profiles are from 1 to 10, except for the ipv6acl profile which is from 0
to 10. The ipv6acl allocation must be a factor of 2 (2, 4, 6, 8, 10).
If you enabled BMP 3.0, to perform a reload on the chassis to upgrade any configuration
changes that have changed the NVRAM content, use the reload conditional nvram-
cfg-change
command.
cam-acl-vlan
Specify the number of VFP blocks allocated to OpenFlow.
S4820T
Syntax
cam-acl-vlan vlanopenflow {0|1} vlaniscsi {0|1}
Defaults Disabled.
Parameters
vlanopenflow Enter the number 1 to allocate VFP blocks and enable OpenFlow.
(Default) Enter the number 0 to disable OpenFlow.
vlaniscsi Enter the number 1 to allocate VFP blocks for iSCSI.
Enter the number 0 to disable iSCSI CAM allocation.
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant FTOS Command Line Reference Guide .
The following is a list of the FTOS version history for this command.
81