Reference Guide

Link Aggregation Control Protocol (LACP)

This chapter contains commands for Dell Networks’s implementation of the link aggregation control protocol (LACP) for

creating dynamic link aggregation groups (LAGs) — known as “port-channels” in the Dell Networking operating

software (FTOS). The LACP commands in this chapter are supported by FTOS on the

S4820T platform.

NOTE: For static LAG commands, refer to Port Channel Commands in the Interfaces chapter), based on the

standards specified in the IEEE 802.3 Carrier sense multiple access with collision detection (CSMA/CD) access

method and physical layer specifications.

clear lacp counters

Clear port channel counters.

S4820T

Syntax

clear lacp port-channel-number counters

Parameters

port-channel-

number

Enter a port-channel number. The range is from 1 to 128.

Defaults Without a Port Channel specified, the command clears all Port Channel counters.

Command Modes

• EXEC

• EXEC Privilege

Command History

This guide is platform-specific. For command information about other platforms, refer to the

relevant

FTOS Command Line Reference Guide

The following is a list of the FTOS version history for this command.

Version 8.3.19.0 Introduced on the S4820T.

Version 8.3.11.1 Introduced on the Z9000.

Version 8.3.7.0 Introduced on the S4810.

Version 7.6.1.0 Introduced on the S-Series.

Version 7.5.1.0 Introduced on the C-Series.

Version 6.2.1.1 Introduced on the E-Series.

Commands

show lacp — displays the LACP configuration.

815