Reference Guide

Defaults Not configured.
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant FTOS Command Line Reference Guide .
The following is a list of the FTOS version history for this command.
Version 9.1(0.0) Added support for output range parameter for S4810 and Z9000.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.5.1.0 Added support for 4-port 40G line cards on ExaScale.
Version 8.3.7.0 Introduced on the S4810.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
pre-Version
6.2.1.1
Introduced on the E-Series.
Example
(Unicast)
mac-address-table static 00:01:00:00:00:01 {output Te 0/2 vlan
2}
Example
(Multicast)
mac-address-table static 01:00:5E:01:00:01 {multicast vlan
2 output—range Te 0/2,Te 0/3}
Related
Commands
show mac-address-table — displays the MAC address table.
mac-address-table station-move threshold
Change the frequency with which the MAC address station-move trap is sent after a MAC address changes in a VLAN. A
trap is sent if a station move is detected above a threshold number of times in a given interval.
S4820T
Syntax
[no] mac-address-table station-move threshold number interval
count
Parameters
threshold number Enter the keyword threshold then the number of times MAC
addresses in VLANs can change before an SNMP trap is sent. The
range is from 1 to 10.
interval seconds Enter the keyword interval then the number of seconds. The
range is from 5 to 60.
Defaults Not configured.
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant FTOS Command Line Reference Guide .
The following is a list of the FTOS version history for this command.
826