Reference Guide

Column Heading Description
• te — 10–Gigabit Ethernet followed by a slot/port.
State Lists if the MAC address is in use (Active) or not in use (Inactive).
The following describes the show mac-address-table count command shown in the
following example.
Line Beginning With Description
MAC Entries... Displays the number of MAC entries learned per VLAN.
Dynamic Address... Lists the number of dynamically learned MAC addresses.
Static Address... Lists the number of user-defined MAC addresses.
Total MAC... Lists the total number of MAC addresses the switch uses.
Example (Count)
FTOS# show mac-address-table count
MAC Entries for all vlans :
Dynamic Address Count : 110
Static Address (User-defined) Count : 0
Sticky Address Count : 0
Total Synced Mac from Peer(N): 100
Total MAC Addresses in Use: 110
FTOS#
Related
Commands
show mac-address-table aging-time — displays MAC aging time.
show mac-address-table aging-time
Display the aging times assigned to the MAC addresses on the switch.
S4820T
Syntax
show mac-address-table aging-time [vlan vlan-id]
Parameters
vlan vlan-id (OPTIONAL) Enter the keyword vlan then the VLAN ID to display the
MAC address assigned to the VLAN. The range is from 1 to 4094.
Command Modes
• EXEC
• EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant FTOS Command Line Reference Guide .
The following is a list of the FTOS version history for this command.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
837