Reference Guide

The following is a list of the FTOS version history for this command.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
pre-Version
6.2.1.1
Introduced on the E-Series.
Example
FTOS(conf-if-vl-100)#show config
!
interface Vlan 100
no ip address
no shutdown
FTOS(conf-if-vl-100)#
show vlan
Display the current VLAN configurations on the switch.
S4820T
Syntax
show vlan [brief | id vlan-id | name vlan-name]
Parameters
brief (OPTIONAL) Enter the keyword brief to display the following
information:
• VLAN ID
• VLAN name (left blank if none is configured)
• Spanning Tree Group ID
• MAC address aging time
• IP address
id vlan-id (OPTIONAL) Enter the keyword id then a number from 1 to 4094. Only
information on the VLAN specified is displayed.
name vlan-name (OPTIONAL) Enter the keyword name then the name configured for
the VLAN. Only information on the VLAN named is displayed.
Command Modes
• EXEC
• EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant FTOS Command Line Reference Guide .
The following is a list of the FTOS version history for this command.
843