Reference Guide

fefd reset
Reset all interfaces or a single interface that was in “error-disabled” mode.
S4820T
Syntax
fefd reset [interface]
Parameters
interface (OPTIONAL) Enter the following keywords and slot/port or number
information:
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/ port information.
Defaults Not configured.
Command Modes EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant FTOS Command Line Reference Guide .
The following is a list of the FTOS version history for this command.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.12.0 Introduced on the S4810.
Legacy E-Series
command.
Related
Commands
• fefd — enables far-end failure detection.
fefd-global interval
Configure an interval between FEFD control packets.
S4820T
Syntax
fefd-global interval seconds
To return to the default value, use the no fefd-global interval command.
Parameters
seconds Enter a number as the time between FEFD control packets. The range
is from 3 to 300 seconds. The default is 15 seconds.
Defaults 15 seconds
Command Modes CONFIGURATION
854