Reference Guide

password command to configure a password for the enable command at a specific
privilege level. If no privilege level is specified, the default is privilege level 15.
Related
Commands
enable password — configures a password for the enable command and to access a
privilege level.
enable optic-info-update interval
Enable polling intervals of optical information updates for simple network management protocol (SNMP).
S4820T
Syntax
enable optical-info-update interval seconds
To disable optical power information updates, use the no enable optical-info-
update interval command.
Parameters
interval seconds Enter the keyword interval then the polling interval in seconds.
The range is from 120 to 6000 seconds. The default is 300 seconds (5
minutes).
Defaults Disabled
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant FTOS Command Line Reference Guide .
The following is a list of the FTOS version history for this command.
Version 8.3.19.0 Replacement command for the S4820T. Replaces the enable xfp-
power-updates
command.
Version 8.3.11.4 Replacement command for the Z9000. Replaces the enable xfp-
power-updates command
Version 8.3.10.0 Replacement command for the S4810 only. Replaces the enable
xfp-power-updates command.
Usage
Information
To enable polling and to configure the polling frequency, use this command.
86