Reference Guide

Version 8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.5.1.0 Added support for 4-port 40G line cards on ExaScale.
Version 8.3.7.0 Introduced on the S4810.
Version 7.7.1.0 Introduced on the S-Series.
Version 7.6.1.0 Introduced on the C-Series.
Version 7.4.1.0 Introduced on the E-Series.
disable
Enable or disable LLDP.
S4820T
Syntax
disable
To enable LLDP, use the no disable command.
Defaults Enabled, that is no disable.
Command Modes CONFIGURATION (conf-lldp) and INTERFACE (conf-if- interface -lldp)
Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant FTOS Command Line Reference Guide .
The following is a list of the FTOS version history for this command.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.7.1.0 Introduced on the S-Series.
Version 7.6.1.0 Introduced on the C-Series.
Version 7.4.1.0 Introduced on the E-Series.
Related
Commands
protocol lldp (Configuration) — enables LLDP globally.
debug lldp interface — debugs LLDP.
show lldp neighbors — displays the LLDP neighbors.
show running-config lldp — displays the LLDP running configuration.
hello
Configure the rate at which the LLDP control packets are sent to its peer.
S4820T
Syntax
hello seconds
To revert to the default, use the no hello seconds command.
865