Reference Guide

Related
Commands
protocol lldp (Configuration) — enables LLDP globally.
show lldp neighbors — displays the LLDP neighbors.
multiplier
Set the number of consecutive misses before LLDP declares the interface dead.
S4820T
Syntax
multiplier integer
To return to the default, use the no multiplier integer command.
Parameters
integer Enter the number of consecutive misses before the LLDP declares the
interface dead. The range is from 2 to 10.
Defaults 4 x hello
Command Modes CONFIGURATION (conf-lldp) and INTERFACE (conf-if- interface -lldp)
Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant FTOS Command Line Reference Guide .
The following is a list of the FTOS version history for this command.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.7.1.0 Introduced on the S-Series.
Version 7.6.1.0 Introduced on the C-Series.
Version 7.4.1.0 Introduced on the E-Series.
protocol lldp (Configuration)
Enable the LLDP globally on the switch.
S4820T
Syntax
protocol lldp
To disable LLDP globally on the chassis, use the no protocol lldp command.
Defaults Enabled.
Command Modes CONFIGURATION (conf-lldp)
Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant FTOS Command Line Reference Guide .
The following is a list of the FTOS version history for this command.
Version 8.3.19.0 Introduced on the S4820T.
867