Reference Guide

Parameters
interface (OPTIONAL) Enter the following keywords and slot/port or number
information:
• For a Fast Ethernet interface, enter the keyword
FastEthernet then the slot/ port information.
• For a 10-Gigabit Ethernet interface, enter the keyword
tenGigabitEthernet then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
detail (OPTIONAL) Enter the keyword detail to display all the TLV
information, remote management IP addresses, timers, and LLDP tx
and rx counters.
Defaults none
Command Modes EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant FTOS Command Line Reference Guide .
The following is a list of the FTOS version history for this command.
Version 9.1.(0.0) Modified output of detail parameter to display remote management IP
addresses.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.5.1.0 Added support for 4-port 40G line cards on ExaScale.
Version 8.3.7.0 Introduced on the S4810.
Version 7.7.1.0 Introduced on the S-Series.
Version 7.6.1.0 Introduced on the C-Series.
Version 7.4.1.0 Introduced on the E-Series.
Usage
Information
Omitting the keyword detail displays only the remote chassis ID, Port ID, and Dead Interval.
Example
R1(conf-if-gi-1/31)#do show lldp neighbors
Loc PortID Rem Host Name Rem Port Id Rem Chassis Id
--------------------------------------------------------------
Gi 1/21 R2 GigabitEthernet 2/11 00:01:e8:06:95:3e
Gi 1/31 R3 GigabitEthernet 3/11 00:01:e8:09:c2:4a
869