Reference Guide

exec-banner
Enable the display of a text string when the user enters EXEC mode.
S4820T
Syntax
exec-banner
To disable the banner on terminal lines, use the no exec-banner command.
Defaults Enabled on all lines (if configured, the banner appears).
Command Modes LINE
Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant FTOS Command Line Reference Guide .
The following is a list of the FTOS version history for this command.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.3.7.0 Introduced on the S4810.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.1.1.0 Introduced on the E-Series ExaScale.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
E-Series Original command.
Usage
Information
Optionally, use the banner exec command to create a text string that is displayed when you
access EXEC mode. This command toggles that display.
Related
Commands
banner exec — configures a banner to display when entering EXEC mode.
line — enables and configures console and virtual terminal lines to the system.
exec-timeout
Set a time interval that the system waits for input on a line before disconnecting the session.
S4820T
Syntax
exec-timeout minutes [seconds]
To return to default settings, use the no exec-timeout command.
Parameters
minutes Enter the number of minutes of inactivity on the system before
disconnecting the current session. The range is from 0 to 35791. The
default is 10 minutes for the console line and 30 minutes for the VTY
line.
88