Reference Guide

clear ip msdp sa-cache
Clears the entire source-active cache, the source-active entries of a particular multicast group, rejected, or local
source-active entries.
S4820T
Syntax
clear ip msdp sa-cache [group-address | rejected-sa | local]
Parameters
group-address Enter the group IP address in dotted decimal format (A.B.C.D.).
rejected-sa Enter the keywords rejected-sa to clear the cache source-active
entries that are rejected because the RPF check failed, an SA filter or
limit is configured, the RP or MSDP peer is unreachable, or because
of a format error.
local Enter the keyword local to clear out local PIM advertised entries. It
applies the redistribute filter (if present) while adding the local PIM
SA entries to the SA cache.
Defaults Without any options, this command clears the entire source-active cache.
Command Modes EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant FTOS Command Line Reference Guide .
The following is a list of the FTOS version history for this command.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.1 Introduced on the S4810.
Version 7.8.1.0 Added the local option.
Version 7.7.1.0 Added the rejected-sa option.
Version 6.2.1.1 Introduced
clear ip msdp statistic
Clears the entire source-active cache, the source-active entries of a particular multicast group, rejected, or local
source-active entries.
S4820T
Syntax
clear ip msdp sa-cache [group-address | rejected-sa | local]
Parameters
group-address Enter the group IP address in dotted decimal format (A.B.C.D.).
882