Reference Guide

ip msdp default-peer
Define a default peer from which to accept all source-active (SA) messages.
S4820T
Syntax
ip msdp default-peer peer address [list name]
To remove the default peer, use the no ip msdp default-peer {peer address}
list name command.
Parameters
peer address Enter the peer address in a dotted decimal format (A.B.C.D.)
list name Enter the keywords list name and specify a standard access list
that contains the RP address that should be treated as the default
peer. If no access list is specified, then all SAs from the peer are
accepted.
Defaults Not configured.
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant FTOS Command Line Reference Guide .
The following is a list of the FTOS version history for this command.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.8.1.0 Added the list option and removed the prefix-list option.
Version 7.4.1.0 Introduced
Usage
Information
If a list is not specified, all SA messages received from the default peer are accepted. You can
enter multiple default peer commands.
ip msdp log-adjacency-changes
Enable logging of MSDP adjacency changes.
S4820T
Syntax
ip msdp log-adjacency-changes
To disable logging, use the no ip msdp log-adjacency-changes command.
Defaults Not configured.
Command Modes CONFIGURATION
885