Reference Guide

ip msdp peer
Configure an MSDP peer.
S4820T
Syntax
ip msdp peer peer address [connect-source] [description] [sa-
limit number]
To remove the MSDP peer, use the no ip msdp peer peer address [connect-
source interface] [description name] [sa-limit number] command.
Parameters
peer address Enter the peer address in a dotted decimal format (A.B.C.D.).
connect-source
interface
Enter the keywords connect-source then one of the interfaces
and slot/port or number information:
• For a Fast Ethernet interface, enter the keyword
FastEthernet then the slot/ port information.
• For a Loopback interface, enter the keyword loopback
then a number from 0 to 16383.
• For a Port Channel interface, enter the keywords port-
channel
then a number. The range is from 1 to 128.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
• For a VLAN, enter the keyword vlan then a number from 1 to
4094.
description name (OPTIONAL) Enter the keyword description then a description name
(maximum 80 characters) to designate a description for the MSDP
peer.
sa-limit number (OPTIONAL) Enter the maximum number of SA entries in SA-cache.
The range is from 1 to 500000. The default it 500000.
Defaults As described in the Parameters section.
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant FTOS Command Line Reference Guide .
The following is a list of the FTOS version history for this command.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.5.1.0 Added support for 4-port 40G line cards on ExaScale.
Version 7.5.1.0 Added option for SA upper limit and the description option.
888