Reference Guide

Version 6.2.1.1 Introduced
ip multicast-msdp
Enable MSDP.
S4820T
Syntax
ip multicast-msdp
To exit MSDP, use the no ip multicast-msdp command.
Defaults Not configured.
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant FTOS Command Line Reference Guide .
The following is a list of the FTOS version history for this command.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 6.2.1.1 Introduced
show ip msdp
Display the MSDP peer status, SA cache, or peer summary.
S4820T
Syntax
show ip msdp {peer peer address | sa-cache | summary}
Parameters
peer peer
address
Enter the keyword peer then the peer address in a dotted decimal
format (A.B.C.D.).
sa-cache Enter the keywords sa-cache to display the Source-Active cache.
summary Enter the keyword summary to display an MSDP peer summary.
Defaults Not configured.
Command Modes
• EXEC
892