Reference Guide

Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant FTOS Command Line Reference Guide .
The following is a list of the FTOS version history for this command.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
pre-Version
6.2.1.1
Introduced on the E-Series.
Usage
Information
MSTP is not enabled when you enter MULTIPLE SPANNING TREE mode. To enable MSTP
globally on the switch, enter the no disable command while in MULTIPLE SPANNING TREE
mode.
For more information about the multiple spanning tree protocol, refer to the FTOS Configuration
Guide .
Example
FTOS(conf)#protocol spanning-tree mstp
FTOS(config-mstp)#no disable
Related
Commands
disable — disables multiple spanning tree.
revision
The revision number for the multiple spanning tree configuration.
S4820T
Syntax
revision range
To return to the default values, use the no revision command.
Parameters
range Enter the revision number for the MST configuration. The range is
from 0 to 65535. The default is 0.
Defaults 0
Command Modes MULTIPLE SPANNING TREE
Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant FTOS Command Line Reference Guide .
The following is a list of the FTOS version history for this command.
902