Reference Guide

distribute-list in
Apply a filter to incoming routing updates from OSPF to the routing table.
S4820T
Syntax
distribute-list prefix-list-name in [interface]
To delete a filter, use the no distribute-list prefix-list-name in
[interface] command.
Parameters
prefix-list-name Enter the name of a configured prefix list.
interface (OPTIONAL) Enter one of the following keywords and slot/port or
number information:
• For Port Channel groups, enter the keywords port-
channel then a number. For the C-Series and S-Series, the
range is from 1 to 128.
• For a SONET interface, enter the keyword sonet then the
slot/port information.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a VLAN, enter the keyword vlan then a number from 1 to
4094.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
Defaults Not configured.
Command Modes ROUTER OSPF
Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant FTOS Command Line Reference Guide .
The following is a list of the FTOS version history for this command.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.8.1.0 Added support for the Multi-Process OSPF.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
pre-Version
6.1.1.1
Introduced on the E-Series.
938