Reference Guide

distribute-list out
To restrict certain routes destined for the local routing table after the SPF calculation, apply a filter.
S4820T
Syntax
distribute-list prefix-list-name out [bgp | connected | isis |
rip | static]
To remove a filter, use the no distribute-list prefix-list-name out [bgp
| connected | isis | rip | static] command.
Parameters
prefix-list-name Enter the name of a configured prefix list.
bgp (OPTIONAL) Enter the keyword bgp to specify that BGP routes are
distributed.
NOTE: BGP and ISIS routes are not available on the C-Series.
BGP, ISIS, and RIP routes are not available on the S-Series.
connected (OPTIONAL) Enter the keyword connected to specify that
connected routes are distributed.
isis (OPTIONAL) Enter the keyword isis to specify that IS-IS routes are
distributed.
NOTE: BGP and ISIS routes are not available on the C-Series.
BGP, ISIS, and RIP routes are not available on the S-Series.
rip (OPTIONAL) Enter the keyword rip to specify that RIP routes are
distributed.
NOTE: BGP and ISIS routes are not available on the C-Series.
BGP, ISIS, and RIP routes are not available on the S-Series.
static (OPTIONAL) Enter the keyword static to specify that only manually
configured routes are distributed.
Defaults Not configured.
Command Modes ROUTER OSPF
Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant FTOS Command Line Reference Guide .
The following is a list of the FTOS version history for this command.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.8.1.0 Added support for the Multi-Process OSPF.
Version 7.6.1.0 Introduced on the S-Series.
939