Reference Guide

ip ftp source-interface

Specify an interface’s IP address as the source IP address for FTP connections.

S4820T

Syntax

ip ftp source-interface interface

To delete an interface, use the no ip ftp source-interface interface

command.

Parameters

interface

Enter the following keywords and slot/port or number information:

• For Loopback interfaces, enter the keyword loopback then

a number from zero (0) to 16383.

• For a Port Channel interface, enter the keyword port-

channel then a number. The range is from 1 to 128.

• For a 10-Gigabit Ethernet interface, enter the keyword

TenGigabitEthernet then the slot/port information.

• For a 40-Gigabit Ethernet interface, enter the keyword

fortyGigE then the slot/port information.

• For a VLAN interface, enter the keyword vlan then a

number from 1 to 4094.

• For a tunnel interface, enter the keyword tunnel.

Defaults The IP address on the system that is closest to the Telnet address is used in the outgoing

packets.

Command Modes CONFIGURATION

Command History

This guide is platform-specific. For command information about other platforms, refer to the

relevant

FTOS Command Line Reference Guide

The following is a list of the FTOS version history for this command.

Version 8.3.19.0 Introduced on the S4820T.

Version 8.3.11.1 Introduced on the Z9000.

Version 8.3.7.0 Introduced on the S4810.

Version 8.5.1.0 Added support for 4-port 40G line cards on ExaScale.

Version 8.2.1.0 Increased number of VLANs on ExaScale to 4094 (was 2094).

Version 8.1.1.0 Introduced on the E-Series ExaScale.

Version 7.6.1.0 Introduced on the S-Series.

Version 7.5.1.0 Introduced on the C-Series.

E-Series Original command.

Commands

copy — copies files from and to the switch.