Reference Guide

pre-Version
6.1.1.1
Introduced on the E-Series.
mib-binding
Enable this OSPF process ID to manage the SNMP traps and process SNMP queries.
S4820T
Syntax
mib-binding
To mib-binding on this OSPF process, use the no mib-binding command.
Defaults none.
Command Modes ROUTER OSPF
Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant FTOS Command Line Reference Guide .
The following is a list of the FTOS version history for this command.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.8.1.0 Introduced to all platforms.
Usage
Information
This command is either enabled or disabled. If no OSPF process is identified as the MIB
manager, the first OSPF process is used.
If an OSPF process has been selected, it must be disabled prior to assigning new process ID
the MIB responsibility.
network area
Define which interfaces run OSPF and the OSPF area for those interfaces.
S4820T
Syntax
network ip-address mask area area-id
To disable an OSPF area, use the no network ip-address mask area area-id
command.
Parameters
ip-address Specify a primary or secondary address in dotted decimal format. The
primary address is required before adding the secondary address.
mask Enter a network mask in /prefix format. (/x)
area-id Enter the OSPF area ID as either a decimal value or in a valid IP
address. Decimal value range is from 0 to 65535. IP address format is
dotted decimal format A.B.C.D.
954