Reference Guide
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.9.1.0 Added support for VRF.
Version 7.8.1.0 Added support for Multi-Process OSPF.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
pre-Version
6.1.1.1
Introduced on the E-Series.
Usage
Information
You must have an IP address assigned to an interface to enter ROUTER OSPF mode and
configure OSPF.
After the OSPF process and the VRF are tied together, you cannot use the OSPF Process ID
again in the system.
Example
FTOS(conf)#router ospf 2
FTOS(conf-router_ospf)#
show config
Display the non-default values in the current OSPF configuration.
S4820T
Syntax
show config
Command Modes ROUTER OSPF
Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant
FTOS Command Line Reference Guide
.
The following is a list of the FTOS version history for this command.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
pre-Version
6.1.1.1
Introduced on the E-Series.
Example
FTOS(conf-router_ospf)#show config
!
router ospf 3
passive-interface FastEthernet 0/1
FTOS(conf-router_ospf)#
962