Reference Guide

• For loopback interfaces, enter the keyword loopback then
a number from 0 to 16383.
• For tunnel interfaces, enter the keyword tunnel then a
number from 0 to 16383.
• For Port Channel groups, enter the keywords port-
channel then a number. The range is from 1 to 128.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a VLAN, enter the keyword vlan then the VLAN ID. The
range is from 1 to 4094.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
Command Modes
• EXEC
• EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant FTOS Command Line Reference Guide .
The following is a list of the FTOS version history for this command.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.8.1.0 Added support for Multi-Process OSPF.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
pre-Version
6.1.1.1
Introduced on the E-Series.
Usage
Information
The following describes the show ip ospf process-id interface command
shown in the following example.
Item Description
GigabitEthernet... This line identifies the interface type slot/port and the status of the
OSPF protocol on that interface.
Internet Address... This line displays the IP address, network mask and area assigned to
this interface.
Process ID... This line displays the OSPF Process ID, Router ID, Network type and
cost metric for this interface.
Transmit Delay... This line displays the interface’s settings for Transmit Delay, State,
and Priority. In the State setting, BDR is Backup Designated Router.
Designated Router... This line displays the ID of the Designated Router and its interface
address.
983