Reference Guide

Command Modes CONFIGURATION

Command History

This guide is platform-specific. For command information about other platforms, refer to the

relevant

FTOS Command Line Reference Guide

The following is a list of the FTOS version history for this command.

Verison 8.3.19.0 Introduced on the S4820T.

Version 8.3.11.1 Introduced on the Z9000.

Version 8.3.7.0 Introduced on the S4820T.

Version 8.5.1.0 Added support for 4-port 40G line cards on ExaScale.

Version 8.2.1.0 Increased number of VLANs on ExaScale to 4094 (was 2094).

Version 8.1.1.0 Introduced on the E-Series ExaScale.

Version 7.6.1.0 Introduced on the S-Series.

Version 7.5.1.0 Introduced on the C-Series.

E-Series Original command

line

Enable and configure console and virtual terminal lines to the system. This command accesses LINE mode, where you

can set the access conditions for the designated line.

S4820T

Syntax

line {console 0 | vty number [end-number]}

Parameters

console 0 Enter the keyword console 0 to configure the console port. The

console option for the S-Series is <0-0>.

vty

number

Enter the keyword vty then a number from 0 to 9 to configure a

virtual terminal line for Telnet sessions. The system supports 10

Telnet sessions.

end-number

(OPTIONAL) Enter a number from 1 to 9 as the last virtual terminal line

to configure. You can configure multiple lines at one time.