Reference Guide

The following is a list of the FTOS version history for this command.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.8.0 Introduced on the S4810.
Example
FTOS#show ip ospf 10 timers rate-limit
List of LSAs in rate limit Queue
LSA id: 1.1.1.0 Type: 3 Adv Rtid: 3.3.3.3 Expiry time:
00:00:09.111
LSA id: 3.3.3.3 Type: 1 Adv Rtid: 3.3.3.3 Expiry time:
00:00:23.96
FTOS#
show ip ospf topology
Display routers in directly connected areas.
S4820T
Syntax
show ip ospf process-id topology
Parameters
process-id Enter the OSPF Process ID to show a specific process. If no Process
ID is entered, command applies only to the first OSPF process.
Defaults none
Command Modes
• EXEC
• EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant FTOS Command Line Reference Guide .
The following is a list of the FTOS version history for this command.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.8.1.0 Added support for Multi-Process OSPF.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series and E-Series.
Usage
Information
To isolate problems with inter-area and external routes, use this command. In OSPF inter-area
and external routes are calculated by adding LSA cost to the cost of reaching the router. If an
inter-area or external route is not of correct cost, the display can determine if the path to the
originating router is correct or not.
991