Users Guide

key-encryption-
type
(OPTIONAL) Species if the key is encrypted.
Valid values: 0 (key is not encrypted) or 7 (key is encrypted).
key
Text string used in authentication.
For MD5 authentication, the key must be 32 hex digits (non-encrypted) or 64 hex
digits (encrypted).
For SHA-1 authentication, the key must be 40 hex digits (non-encrypted) or 80 hex
digits (encrypted).
Defaults Not congured.
Command Modes INTERFACE
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.2(1.0) Introduced on the Z9500.
9.1.(0.0) Introduced on S4810 and Z9000.
8.4.2.0 Introduced on the E-Series.
8.3.19.0 Introduced on the S4820T.
Usage Information
Before you enable IPsec authentication on an OSPFv3 interface, rst enable IPv6 unicast routing globally,
congure an IPv6 address and enable OSPFv3 on the interface, and assign the interface to an area.
An SPI value must be unique to one IPsec security policy (authentication or encryption) on the router.
Congure the same authentication policy (same SPI and key) on each OSPFv3 interface in a link.
To remove an IPsec authentication policy from an interface, enter the no ipv6 ospf authentication spi
number command. To remove null authentication on an interface to allow the interface to inherit the
authentication policy congured for the OSPFv3 area, enter the no ipv6 ospf authentication
null command.
Related Commands
area authentication – congures an IPsec authentication policy for an OSPFv3 area.
show crypto ipsec policy – displays the conguration of IPsec authentication policies.
show crypto ipsec sa ipv6 – displays the security associations set up for OSPFv3 interfaces in
authentication policies.
Open Shortest Path First (OSPFv2 and OSPFv3)
1207