Users Guide

ip pim rp-address
Congure a static PIM rendezvous point (RP) address for a group or access-list.
S4820T
Syntax
ip pim [vrf vrf-name] rp-address address {group-address group-address mask}
[override]
To remove an RP address, use the no ip pim [vrf vrf-name] rp-address address {group-
address group-address mask} [override] command.
Parameters
vrf vrf-name (OPTIONAL) Enter the keyword vrf followed by the name of the VRF.
NOTE: Applies to specic VRF if input is provided, else applies to Default
VRF.
address Enter the RP address in dotted decimal format (A.B.C.D).
group-address
group-address
mask
Enter the keywords group-address then a group-address mask, in dotted
decimal format (/xx), to assign that group address to the RP.
override Enter the keyword override to override the BSR updates with static RP. The
override takes eect immediately during enable/disable.
NOTE: This option is applicable to multicast group range.
Defaults Not congured.
Command Modes CONFIGURATION
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Added support for VRF. Introduced on the S6000-ON.
9.5(0.1) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series ExaScale.
7.8.1.0 Introduced on the S-Series.
pre- 6.1.1.1 Introduced on the E-Series.
PIM-Sparse Mode (PIM-SM)
1249