Users Guide

show ip pim neighbor
View PIM neighbors.
S4820T
Syntax
show ip pim [vrf vrf-name] neighbor
Parameters
vrf vrf-name (OPTIONAL) Enter the keyword vrf followed by the name of the VRF to
congure this setting on that VRF.
NOTE: Applies to specic VRF if input is provided, else applies to Default
VRF.
Command Modes
• EXEC
• EXEC Privilege
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Added support for VRF. Introduced on the S6000-ON.
9.5(0.1) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Introduced on the S4810.
8.3.11.1 Introduced on the Z9000.
8.1.1.0 Introduced on the E-Series ExaScale.
7.8.1.0 Introduced on the S-Series.
Usage Information The following describes the show ip pim neighbor command shown in the following example.
Field Description
Neighbor address Displays the IP address of the PIM neighbor.
Interface List the interface type, with either slot/port information or ID (VLAN or Port
Channel), on which the PIM neighbor was found.
Uptime/expires Displays the amount of time the neighbor has been up then the amount of time
until the neighbor is removed from the multicast routing table (that is, until the
neighbor hold time expires).
Ver Displays the PIM version number.
• v2 = PIM version 2
1258
PIM-Sparse Mode (PIM-SM)