Users Guide

set ip ttl Congures the IP time-to-live (TTL) value of the Encapsulated Remote Switched
Port Analyzer (ERSPAN) trac. To revert to the default conguration, use the no
form of this command.
ttl_value IP TTL value of the ERSPAN trac. The range is from 1 to 255. The default value is
255.
drop Monitors only the dropped packets in the Ingress.
Defaults none
Command Modes CONFIGURATION
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.8(0.0) Added the drop parameter.
9.7(0.0) Introduced on the S6000-ON. Introduced the set ip dscp and set ip ttl
parameters.
9.5(0.1) Introduced on the Z9500.
9.4(0.0) Introduced on the S4810, S4820T, S6000, and Z9000.
9.0.2.0 Introduced on the S6000.
9.0.2.0 Introduced on the MXL.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
Usage Information The monitor command is saved in the running conguration at Monitor Session mode level and can be
restored after a chassis reload.
Example
Dell#show monitor session
SessID Source Destination Dir Mode Source IP Dest IP DSCP TTL
------ ------ ----------- --- ---- --------- ---------------
0 Te 1/12 remote-ip rx Flow 1.1.1.1 7.1.1.2 0 255
0 Po 1 remote-ip tx Flow 1.1.1.1 7.1.1.2 0 255
1 Vl 11 remote-ip rx Flow 5.1.1.1 3.1.1.2 0 255
Related Command
show monitor session — displays the monitor session.
show running-cong monitor session — displays the running conguration of a monitor session.
Port Monitoring
1271