Users Guide

Usage Information By default, when rate policing and shaping, the system does not include the Preamble, SFD, or the IFG
elds. These elds are overhead; only the elds from MAC destination address to the CRC are used for
forwarding and are included in these rate metering calculations.
Per-Port QoS Commands
Per-port QoS (port-based QoS) allows you to dene the QoS conguration on a per-physical-port basis.
dot1p-priority
Assign a value to the IEEE 802.1p bits on the trac this interface receives.
Syntax
dot1p-priority priority-value
To delete the IEEE 802.1p conguration on the interface, use the no dot1p-priority command.
Parameters
priority-value Enter a value from 0 to 7.
dot1p Queue Number
0 0
1 0
2 0
3 1
4 2
5 3
6 3
7 3
Defaults none
Command Modes INTERFACE
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
Version
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
Quality of Service (QoS)
1301