Users Guide

For a port channel interface, enter the keywords port-channel then a
number. The range is from 1 to 128.
For a Null interface, enter the keyword null then the Null interface number.
For a VLAN interface, enter the keyword vlan then a number from 1 to 4094.
Defaults Not congured.
Command Modes CONFIGURATION
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.5(0.1) Introduced on the Z9500.
9.5(0.0) Introduced on the Z9500.
9.4(0.0) Introduced on the S-Series and Z9000.
Usage Information
The source-interface interface attribute is applicable for both the SSH client as well as the
COPY (SCP) commands. Using these attributes the client session tags an error to the user during run time,
in case there is a mismatch between this command and the
ip ssh vrf command.
Example
Dell(conf)#ip ssh source-interface tengigabitethernet 1/42
Dell(conf)#do ssh 10.10.10.2 -l admin
Dell(conf)#no ip ssh source-interface
ip ssh server
Congure an SSH server. SSH server is enabled by default.
S4820T
Syntax
NOTE: Some of the parameters in this command require licensing to access. For more information,
contact your Dell Networking representative.
ip ssh server {ciphers cipher-list} {enable | port port-number} [kex key-
exchange-algorithm] [mac hmac-algorithm] [version {1 | 2}]
To disable SSH server functions, use the no ip ssh server {ciphers cipher-list} {enable
| port port-number} [kex key-exchange-algorithm] [mac hmac-algorithm]
[version {1 | 2}] command.
Parameters
enable Enter the key word enable to start the SSH server.
ciphers cipher-list Enter the keyword ciphers and then a space-delimited list of ciphers that the
SSH server supports. The following ciphers are available.
Security
1477