Users Guide

Version Description
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
pre-6.1.1.0 Introduced on the E-Series.
Usage Information This command enables the SSH server and begins listening on a port. If a port is not specied, listening is on
SSH default port 22.
NOTE: Starting with Dell Networking OS Release 9.2(0.0), SSH server is enabled by default.
Example
Dell# conf
Dell(conf)# ip ssh server port 45
Dell(conf)# ip ssh server enable
Dell#
Related Commands show ip ssh — displays the ssh information.
ip ssh server vrf
Congure an SSH server on either a specic VRF or a management VRF.
Syntax
NOTE: Some of the parameters in this command require licensing to access. For more information,
contact your Dell Networking representative.
ip ssh server vrf {management | vrf-name}
To disable the SSH server conguration, use the no ip ssh server vrf {management | vrf-
name} command.
Parameters
vrf management Enter the key word vrf followed by the keyword management to congure an
SSH server on a management VRF.
vrf vrf-name Enter the key word vrf followed by the VRF name to congure an SSH server on
that VRF.
Defaults None
Command Modes CONFIGURATION
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.5(0.1) Introduced on the Z9500.
9.4(0.0) Introduced on the S-Series and Z9000.
1480
Security