Users Guide

Usage Information
Dell Networking OS supports up to 16 SNMP trap receivers.
For the cam-utilization notication option, the system generates syslogs and SNMP traps when the
L3 host table or route table utilization goes above the threshold.
If you do not congure this command, traps that controlled by this command are not sent. If you do not
specify a notification-type and notification-option, all traps are enabled.
Related Commands snmp-server community — enables SNMP and sets the community string.
snmp-server engineID
Congure the name for both the local and remote SNMP engines on the router.
Syntax
snmp-server engineID [local engineID] [remote ip-address vrf vrf-name udp-
port port-number engineID]
To return to the default, use the no snmp-server engineID [local engineID] [remote ip-
address vrf vrf-name udp-port port-number engineID] command.
Parameters
local engineID
Enter the keyword local followed by the engine ID number that identies the
copy of the SNMP on the local device.
Format (as specied in RFC 3411): 12 octets.
• The rst four octets are set to the private enterprise number.
• The remaining eight octets are the MAC address of the chassis.
remote ip-address Enter the keyword remote followed by the IP address that identies the copy of
the SNMP on the remote device.
vrf vrf-name Enter the keyword vrf followed by the name of the VRF that is used to reach the
device.
NOTE: Use this attribute to specify the VRF that is used by the SNMP
engine to reach the device. If no VRF is specied, then the default VRF is
used.
udp-port port-
number engineID
Enter the keywords udp-port followed by the user datagram protocol (UDP) port
number on the remote device. The range is from 0 to 65535. The default is 162.
Defaults As above.
Command Modes CONFIGURATION
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
1526
Simple Network Management Protocol (SNMP) and Syslog