Users Guide

ManualsBrandsDell ManualsAccess PlatformsPowerSwitch S4820T

1571

Parameters

stack-number Enter the stack member unit identier.

1–14 This preference parameter allows you to specify the management priority of one

backup switch over another, with 0 the lowest priority and 14 the highest. The

switch with the highest priority value is chosen to become the management unit if

the active management unit fails or on the next reload.

Defaults 0

Command Modes CONFIGURATION

Command History

This guide is platform-specic. For command information about other platforms, refer to the relevant Dell

Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Version Description

9.8(0.0P5) Introduced on the S4048-ON.

9.8(0.0P2) Introduced on the S3048-ON.

9.7(0.0) Introduced on the S6000.

8.3.19.0 Introduced on the S4820T.

8.3.7.0 Introduced on the S4810.

8.3.11.1 Introduced on the Z9000.

Related Commands

• reload – reboots Dell Networking OS.

stack-unit provision

Precongure a logical stacking ID of a switch that joins the stack. This is an optional command that is executed on the management

unit.

Syntax

stack-unit [stack-number] provision {S4810|S4820T|S6000|Z9000}

Parameters

stack-unit Enter a stack member identier of the switch that you want to add to the stack.

S4810|S4820T|

S6000|Z9000

Enter the model identier of the switch to be added as a stack member. This

identier is also referred to as the provision type.

Defaults When this value is not set, a switch joining the stack is given the next available sequential stack member

identier.