Users Guide

Usage Information Broadcast trac (all 0xFs) should be counted against the broadcast storm control meter, not against the
multicast storm control meter. It is possible, however, that some multicast control trac may get dropped
when storm control thresholds are exceeded.
storm-control multicast (Interface)
Congure the percentage of multicast trac allowed on an C-Series or S-Series interface (ingress only) network only.
Syntax
storm-control multicast packets_per_second in
To disable multicast storm control on the interface, use the no storm-control multicast
packets_per_second in command.
Parameters
packets_per_secon
d in
Enter the packets per second of broadcast trac allowed into the network. The
range is from 0 to 33554368.
Defaults none
Command Modes INTERFACE (conf-if-interface-slot/port)
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.6.1.0 Introduced on the C-series and S-Series.
storm-control unknown-unicast (Conguration)
Congure the percentage of unknown-unicast trac allowed in or out of the network.
Syntax
storm-control unknown-unicast [packets_per_second in]
To disable storm control for unknown-unicast trac, use the no storm-control unknown-unicast
[packets_per_second in] command.
Storm Control
1587