Users Guide

Example (VRRP
VRF)
Dell#show vrrp vrf jay
------------------
TenGigE 1/0, IPv4 VRID: 20, Version: 2, Net: 10.0.0.3
VRF: 1 jay
State: Master, Priority: 100, Master: 10.0.0.3 (local)
Hold Down: 0 sec, Preempt: TRUE, AdvInt: 1 sec
Adv rcvd: 0, Bad pkts rcvd: 0, Adv sent: 38, Gratuitous ARP sent: 0
Virtual MAC address:
00:00:5e:00:01:14
Virtual IP address:
10.0.0.2
Authentication: (none)
Dell#show vrrp vrf jay brief
Interface Group Pri Pre State Master addr Virtual addr(s) Description
---------------------------------------------------------
Te 1/0 IPv4 20 100 Y Master 10.0.0.3 10.0.0.2
Dell#
track
Monitor an interface and lower the priority value of the VRRP group on that interface if it is disabled.
Syntax
track interface [priority-cost cost]
To disable monitoring, use the no track interface command.
Parameters
interface (OPTIONAL) Enter the following keywords and slot/port or number information:
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a Loopback interface, enter the keyword loopback then a number from 0
to 16383.
•
For Port Channel interface types, enter the keywords port-channel then a
number.
• For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the
slot/port information.
• For a VLAN interface, enter the keyword vlan then the VLAN ID. The VLAN
ID range is from 1 to 4094.
priority-cost (OPTIONAL) Enter a number as the amount to subtract from the priority value.
The range is from 1 to 254. The default is 10.
Defaults priority cost = 10
Command Modes VRRP
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
Virtual Router Redundancy Protocol (VRRP)
1723