Users Guide

The software cannot count both packets and bytes, so when you enter the count byte options, only
bytes increment.
Related Commands
ip access-list standard — congures a standard ACL.
permit — congures a permit lter.
ip access-list standard
Create a standard IP access list (IP ACL) to lter based on IP address.
Syntax
ip access-list standard access-list-name
To delete an access list, use the no ip access-list standard access-list-name command.
Parameters
access-list-name Enter a string up to 140 characters long as the ACL name.
Defaults All IP access lists contain an implicit “deny any,” that is, if no match occurs, the packet is dropped.
Command Modes CONFIGURATION
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000–ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.10.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series ExaScale.
7.8.1.0 Increased the name string to accept up to 140 characters.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
7.4.1.0 Added support for the non-contiguous mask and added the monitor option.
6.5.1.0 Expanded to include the optional QoS order priority for the ACL entry.
Usage Information
Dell Networking OS supports one ingress and one egress IP ACL per interface.
Prior to Dell Networking OS version 7.8.1.0, names are up to 16 characters long.
210
Access Control Lists (ACL)