Users Guide

Parameters
sequence-number Enter a number from 0 to 4294967290.
deny Enter the keyword deny to congure a lter to drop packets meeting this
condition.
permit Enter the keyword permit to congure a lter to forward packets meeting this
criteria.
ip-protocol-number Enter a number from 0 to 255 to lter based on the protocol identied in the IP
protocol header.
icmp Enter the keyword icmp to congure an ICMP access list lter.
ip Enter the keyword ip to congure a generic IP access list. The keyword ip
species that the access list permits all IP protocols.
tcp Enter the keyword tcp to congure a TCP access list lter.
udp Enter the keyword udp to congure a UDP access list lter.
source Enter an IP address in dotted decimal format of the network from which the packet
was received.
mask (OPTIONAL) Enter a network mask in /prex format (/x) or A.B.C.D. The mask,
when specied in A.B.C.D format, may be either contiguous or non-contiguous.
any Enter the keyword any to specify that all routes are subject to the lter.
host ip-address Enter the keyword host and then enter the IP address to specify a host IP
address or hostname.
operator (OPTIONAL) Enter one of the following logical operands:
• eq = equal to
• neq = not equal to
• gt = greater than
• lt = less than
• range = inclusive range of ports (you must specify two ports for the port
parameter.)
port port (OPTIONAL) Enter the application layer port number. Enter two port numbers if
you are using the range logical operand. The range is from 0 to 65535.
The following list includes some common TCP port numbers:
• 23 = Telnet
• 20 and 21 = FTP
• 25 = SMTP
• 169 = SNMP
destination Enter the IP address of the network or host to which the packets are sent.
count (OPTIONAL) Enter the keyword count to count packets the lter processes.
byte (OPTIONAL) Enter the keyword byte to count bytes the lter processes.
log (OPTIONAL, E-Series only) Enter the keyword log to enter ACL matches in the
log. Supported on Jumbo-enabled line cards only.
dscp (OPTIONAL) Enter the keyword dcsp to match to the IP DCSCP values.
234
Access Control Lists (ACL)