Users Guide

set tag
To specify a tag for redistributed routes, congure a lter.
Syntax
set tag tag-value
To delete a setting, use the no set tag command.
Parameters
tag-value Enter a number as the tag. The range is from zero (0) to 4294967295.
Defaults Not congured.
Command Modes ROUTE-MAP
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000–ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series ExaScale.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
pre-6.1.1.0 Introduced on the E-Series.
Related Commands
set automatic-tag — computes the tag value of the route.
set level — species the OSPF area for route redistribution.
set metric — species the metric value assigned to redistributed routes.
set metric-type — species the route type assigned to redistributed routes.
set weight
To add a non-RFC compliant attribute to the BGP route to assist with route selection, congure a lter.
Syntax
set weight weight
To delete a weight specication, use the no set weight weight command.
Access Control Lists (ACL)
283