Users Guide

When you remove all clients of a route reector using the no neighbor route-reflector-client
command, the router no longer functions as a route reector.
If the clients of a route reector are fully meshed, you can congure the route reector to not reect routes
to specied clients by using the no bgp client-to-client reflection command.
This command automatically restarts the neighbor session for the conguration to take eect.
Related Commands bgp client-to-client reection — enables route reection between the route reector and the clients.
neighbor send-community
Send a COMMUNITY attribute to a BGP neighbor or peer group. A COMMUNITY attribute indicates that all routes with that
attribute belong to the same community grouping.
S4820T
Syntax
neighbor {ip-address | peer-group-name} send-community [extended |
standard]
To disable sending a COMMUNITY attribute, use the no neighbor {ip-address | peer-group-
name} send-community command.
Parameters
ip-address Enter the IP address of the peer router in dotted decimal format.
peer-group-name Enter the name of the peer group to send a COMMUNITY attribute to all routers
within the peer group.
extended (OPTIONAL) Enter the keyword extended to send extended community
attribute.
standard (OPTIONAL) Enter the keyword standard to send standard community attribute.
Defaults Not congured and COMMUNITY attributes are not sent to neighbors.
Command Modes ROUTER BGP
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000–ON.
9.2(1.0) Introduced on the Z9500.
Version 9.0.2.0 Introduced on the S6000.
8.3.11.1 Introduced on the Z9000.
7.8.1.0 Introduced on the S-Series.
7.7.1.0 Introduced on the C-Series.
Usage Information To congure a COMMUNITY attribute, use the set community command in ROUTE-MAP mode.
414
Border Gateway Protocol