Users Guide

show ip bgp
View the current BGP IPv4 routing table for the system.
S4820T
Syntax
show ip bgp [vrf vrf-name] [ipv4 unicast] [network [network-mask] [longer-
prefixes]]
Parameters
vrf vrf-name (OPTIONAL) Enter the keyword vrf and then the name of the VRF to view ipv4–
unicast route information corresponding to that VRF.
ipv4 unicast (OPTIONAL) Enter the keywords ipv4 unicast to view information only related
to ipv4 unicast routes.
network (OPTIONAL) Enter the network address (in dotted decimal format) of the BGP
network to view information only on that network.
network-mask (OPTIONAL) Enter the network mask (in slash prex format) of the BGP network
address.
longer-prexes (OPTIONAL) Enter the keywords longer-prefixes to view all routes with a
common prex.
Command Modes
• EXEC
• EXEC Privilege
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000–ON.
9.4.(0.0) Added support for VRF.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.8.0 Added the add-path option to the S4810. Output on the S4810 shows the
ADDPATH parameters.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
7.7.1.0 Introduced on the C-Series.
Usage Information When you enable the bgp non-deterministic-med command, the show ip bgp command output
for a BGP route does not list the INACTIVE reason.
Border Gateway Protocol
429